Installation Process

Pool Copings & Steps - Wet Set coping material in high strength light mortar mix. Separate each piece of coping by 1/4 inch. Fill separation joints and entire stone with exterior grout. Seal stones with natural stone sealer and replace before the life of the sealer ends.

 

Paver installation with concrete base: Pour minimum of 4 inches of 4000 psi strength wire reinforced concrete for base. Wet set each stone into high strength mortar mix. Separate all pieces by 1/4 inch. Fill all stone voids and separation joints with exterior grout. Seal stones with natural stone natural look sealer and replace before the life of the sealer ends. Stones can also be dry laid over concrete base using sand to level on top of poured concrete base and later swept with polymeric sand.

 

Paver installation with RCA base: Excavate area and install a minimum of 6 inches of RCA (Recycled Concrete Aggregate) and compact with vibratory compaction equipment. RCA should be high quality produced with 95% aggregate which will allow for good drainage. Level 1 inch sand bed on top of RCA and install pavers with no joint butting pieces as tightly as possible. Fill paver with polymeric sand. Seal stones with natural stone sealer and replace before the life of the sealer ends.

 

ALL FRENCH PATTERN PAVERS SOLD AS SETS INCLUDING 4 pieces-8X8, 2 pieces-8X16, 4 pieces16X16, 2-pieces-16X24 Total=16 square feet per set